“All shaft reset” only clears the working coordinates, is it currently displaying the machine coordinates, and “clr origin” is the clearing machine coordinates.
or please check if you change Machine – home– referenceCoor–Zero DCoor,the default is 0

“All shaft reset” only clears the working coordinates, is it currently displaying the machine coordinates, and “clr origin” is the clearing machine coordinates.
or please check if you change Machine – home– referenceCoor–Zero DCoor,the default is 0
Comments are closed.
i have gought and installed this controller and would like some help setting up the probe and other options
Hallo
Habe selbes Problem.
Brauche einen Schaltplan oder wie alle Anschlüsse funktionieren.
Wie z. B. Limit z min oder z max. Oder was ust IN 1 bis IN22?
Bitte um hilfe!
Ernstullmann@web.de
The function of the IN input port is not fixed
The port number is set in that function item, what is the function of this port
I just received my smc5-5-5-n-n controller. I cannot find The settings to be able to slave the A axis to the Y axis. My CNC machine has 2 stepper Motors on the Y axis typically you slave the A axis to the Y axis. How do you solve this problem?
you can connect two axis drive signals in parallel, or use an expansion board
After wiring a two motor y gantry in parallel driver and motor with single signal, is there any way to wire two limit switches to auto square y axes with x axes?
The dual Y-axis cannot be automatically balanced unless you add a circuit to identify it.
If it is just a limit, you can make 2 limit switches in series or parallel
hallo
hat mir jemand einen vollstandigen schaltplan für alle ein und ausgänge?
finde nirgendwo etwas .
was schliesse ich wo an? IN1 = ?. Und der rest? was ist z.b IN8?
wo schliesse ich HOME Z an? usw.
Bitte um Hilfe
Im Manual.pdf finde ich nichts über die anschlüsse
I received the controller in good condition worked fine . I had multi power supplies and I pugged the wrong one in by mistake. It was a 24 volt instead of the 12 volt supply. where can I get it fixed?
hi,24V can be used normally
This unit looks very good to me and I may use it in a retro fit and several new builds.
I hope I do not have learn the metric system to us this controller. That will limit sales of my new builds. Sure hope there is a update that will work with inch.
see here https://www.shaogecnc.com/smc4-smc5-supports-inches?/