Q :SMC4-4-16A16B and I hace an issue with my first hole. Im using Fusion 360, when I make the instructions for the hole, it seems is an perfect square but the final line, the boundary make a small round in the corner instead a straight 90 degree line.
A:You can try. enabled cvl setting 1,CVL is set to tool or fillet radius

6 replies on “SMC4-4-16A16B make a small round in the corner”
buenas noches,en el manual se encuentra solo la explicacion de como se habilitan y se usan las entradas pero las salidas no explican nada y el test del soware solo se rebisan las entrdas pero nesecito habilitar las salidas donde conecto y como habilito una salida diferente a m8 0 m7 por ejemplo si voy a usar un m301 un m302 o un m101 o un m102 m103 cual puerto (pin en SOFWARE) ES ? DE CADA UNO POR FAVOR ME URGE
Directly control the output port in the program can use M10x M20x,For example, M101 turns off port 1 and M201 turns on port 1 to GND
Hi, i have this for update ShaoGe: V0.6.1 – Interpolation: V0.5.8 – LookAhead: V0.4.5 – G Code: V0.3.2 – Copyright: 2018-09-16
ID: 55E65608 41466027 8689E0D3, please send the files to my email: davidchaconcnc@gmail.com. Thank you
had send
I have a SMC4-4 16A16B that I bought from you back in 2015. I would like to upgrade the firmware. Please email it to dmauch@seanet.com
V0.5.9
2015-9-20
ID 55CB55D3-41446015-8688E3E2
check email.